Modifiche al passo #7
Modifica di Ryan Bortnick —
Modifica approvata da Ryan Bortnick
- Prima di
- Dopo il
- Invariato
Righe Passo
| [* red] Remove the two 3.0 mm screws on each side of the fan using the Phillips #0 screwdriver. | |
| [* icon_note] Only one screw is shown being removed. | |
| [* orange] Gently remove the fan's power supply by pulling up on the small white connector (with orange and red wires). | |
| [* icon_caution] Avoid pulling on the wires while removing the power supply, as this will cause permanent damage. | |
| - | [* black] Slowly slide out the fan from the heat sink and lift it out from the back of the laptop. |
| - | [* black] Clean the fan and heat sink with compressed air or replace the fan. |
| + | [* black] Slowly lift up and slide out the fan from the CPU (heat sink) and back of the laptop. |