Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Oliver-

Modifica rifiutata da David Hodson

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_note] If necessary, peel the EMI gasket off the camera cable connector.
[* black] Disconnect the camera cable by pulling the male end straight away from its socket toward the optical drive opening.
[* icon_caution] Do not try to lift this connector straight up off the board. Pull the connector parallel to the face of the logic board.
[* black] The connector may be fixed by a little black plastic block on the board. This block is only glued, you need to remove it, otherwise the connector must be lifted and gets easily damaged.
[* black] Deroute the camera data cable from the channel in the optical drive.