Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Andrew Bookholt-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_note] If necessary, peel the EMI gasket off the camera cable connector.
[* black] Disconnect the camera cable by pulling the male end straight away from its socketsocket toward the optical drive opening.
[* icon_caution] Do not try to lift this connector straight up off the board. Pull the connector parallel to the face of the logic board
.
[* black] Disconnect the camera cable by pulling the male end straight away from its socketsocket toward the optical drive opening.
[* icon_caution] Do not try to lift this connector straight up off the board. Pull the connector parallel to the face of the logic board
.
[* black] Deroute the camera data cable from the channel in the optical drive.

Immagine 1

Vecchia Versione

Nuova Versione