Salta al contenuto principale

Modifiche al passo #17

Modifica in base a Michael Vovaris-

Modifica rifiutata da Sam Goldheart

Prima di
Dopo il
Invariato

Righe Passo

[* red] Remove two 7 mm Phillips screws securing the DC-in board to the upper case.
-[* icon_note] Note: This step is not completely necessary, but it will make it easier to disconnect the cable that is connected to the DC-in board.
+[* icon_note] Note: This step is not completely necessary, but it will make it easier to disconnect the cable that is connected to the DC-in board as well as Step 26's Battery Connector removal.