Modifiche al passo #6
Righe Passo
| + | [* black] The battery must be removed by desoldering the two positions shown. Take note of the polarity of the battery before removal. |
|---|---|
| + | [* black] Desolder the points and remove the battery. |
| + | [* black] Solder the new battery in place, maintaining polarity. |
| + | [* black] New battery installed here - the new battery had a plastic ring around it. The tabs may be in slightly different positions and may require manipulation to fit into the existing location |
| + | [* black] Once the battery has been connected, check the display panel to see if the clock is flashing - this will indicate the battery is connected. |
Immagine 1
Nessuna immagine precedente.
Aggiunto
Immagine 2
Nessuna immagine precedente.
Aggiunto
Immagine 3
Nessuna immagine precedente.
Aggiunto