Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Miroslav Djuric-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_note] To aid in soldering the new battery, be sure the solder pad holes of the solder pads are clear of solder. This way, you can insert the new battery leads and solder them in place.
[* icon_note] To aid in soldering the new battery, be sure the solder pad holes of the solder pads are clear of solder. This way, you can insert the new battery leads and solder them in place.
[* black] To open the solder holes, open a safety pin and push it against the solder blocking the hole. At the same time, heat the same solder pad from the other side of the logic board. Opening the holes completely will require repeating this procedure several times from alternating sides of the logic board.
[* icon_caution] These holes are extremely small, so the safety pin will probably be too large to pass all the way through. DoDo not forceinsert the entire pin throughthrough the hole -- only the tip of the pin.
[* icon_caution] Do not overheaticon_note] You can also try entering the logic board. Iftip of the safety pin does not make it through on the first try, allowother side of the logic board to cool down, then reheat the pad. Repeat this process until the safety pin is pushed all the way throughopen the solder pad hole.
[* icon_caution] These holes are extremely small, so the safety pin will probably be too large to pass all the way through. DoDo not forceinsert the entire pin throughthrough the hole -- only the tip of the pin.
[* icon_caution] Do not overheaticon_note] You can also try entering the logic board. Iftip of the safety pin does not make it through on the first try, allowother side of the logic board to cool down, then reheat the pad. Repeat this process until the safety pin is pushed all the way throughopen the solder pad hole.