Menü

Le tue impostazioni

Il mio banco da lavoro

Ottieni un rapido accesso alle guide, ai componenti e alle risposte per i tuoi dispositivi
Il Mio Carrello

Sembra che il tuo carrello sia vuoto

Sfoglia il Nostro Negozio

Modifiche al passo #4

Modifica in base a Miroslav Djuric-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_note] To aid in soldering the new battery, be sure the holes of the solder pads are clear of solder. This way, you can insert the new battery leads and solder them in place.
[* black] To open the solder holes, straightenopen a safety pin and push it against the solder blocking the hole. At the same time, heat the same solder pad from the other side of the logic board.
[* black] To open the solder holes, straightenopen a safety pin and push it against the solder blocking the hole. At the same time, heat the same solder pad from the other side of the logic board.
[* icon_caution] Do not overheat the logic board. If the safety pin does not make it through on the first try, allow the logic board to cool down, then reheat the pad. Repeat this process until the safety pin is pushed all the way through the hole.