Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Miroslav Djuric-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Place the logic board flat on a table with the gold ground contacts (shown in orange) facing up.
[* black] Place the logic board flat on a table with the gold ground contacts (shown in orange) facing up.
[* black] Using a pair of tweezers, insert the stripped ends of the battery leads into their respective holes.
[* black] Insert the black lead into the hole nearest the hold switchswitch (shown in red).
[* black] Insert the black lead into the hole nearest the hold switchswitch (shown in red).
[* black] Insert the red lead into the center hole.
[* black] Insert the white lead into the hole furthest from the hold switch.
[* icon_note] The location ofTo keep the hold switch is shownleads in redplace, it may be helpful to first bend them 90 degrees, and then insert them into the holes.
[* icon_note] The location ofTo keep the hold switch is shownleads in redplace, it may be helpful to first bend them 90 degrees, and then insert them into the holes.
[* icon_note] To keep the leads in place, it may be helpful to first bend the battery leads into their final shape, then insert the stripped ends into the holes.

Immagine 1

Vecchia Versione

Nuova Versione