Salta al contenuto principale

Modifiche al passo #2

Modifica in base a iRobot-

Modifica approvata da Andrea

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Pick up the device, so that the underside of the device is facing you. The side of the device that binds the two screens should be on the top, and the side where the device opens, should be on the bottom.
[* black] In this position, you will see
red] Insert a long crease line where the top of the case and the binding meet.
[* black] Take your
blue plastic opening tool, and gently insert it intotool in the crack of the crease line, between the front and back cover to seperateseparate the pieces.
[* black] Pick up the device, so that the underside of the device is facing you. The side of the device that binds the two screens should be on the top, and the side where the device opens, should be on the bottom.
[* black] In this position, you will see
red] Insert a long crease line where the top of the case and the binding meet.
[* black] Take your
blue plastic opening tool, and gently insert it intotool in the crack of the crease line, between the front and back cover to seperateseparate the pieces.
[* icon_caution] Be careful when separating the front and back covers, as the two are held together by a thin wire.
[* black] Separate the halves of the case.