Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Andrea-

Modifica approvata da Andrea

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Removeblack] Find the connection to LCD frompower board located on the top right hand corner of the device. (The LCD power board (pinkwill be the long green circuit board with a pink and white cords) usingwire emerging from the top)
[* black] Using your blue
plastic opening tool.
[* blue] Remove the two 5mm screws with the Phillips number 0.
[* violet] Pick up the board, turn so you can see the bottom of it and
tool, remove the connection (multi-colored, twisted wire) towire connections from the Input/Output board.
[* black] Lift
LCD power board from case.located on the top of the board. (These will be the pink and white wires)
[* red] Removeblack] Find the connection to LCD frompower board located on the top right hand corner of the device. (The LCD power board (pinkwill be the long green circuit board with a pink and white cords) usingwire emerging from the top)
[* black] Using your blue
plastic opening tool.
[* blue] Remove the two 5mm screws with the Phillips number 0.
[* violet] Pick up the board, turn so you can see the bottom of it and
tool, remove the connection (multi-colored, twisted wire) towire connections from the Input/Output board.
[* black] Lift
LCD power board from case.located on the top of the board. (These will be the pink and white wires)

Immagine 2

Eliminato

Immagine 3

Eliminato