Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #1

Modifica in base a Richdave-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* red] The EM10 charging filter is located next to the power connector on the motherboard.
[* black] If you are uncertain if the EM10filter is missing or obviously broken, measure the two sidesmove on to see ifSTEP 18
[* black] Use a multimeter to test
the are connected. IfEM10 filter - measure the resistance between each of the yellow solder pads, and then between each of the cyan solder pads. If everything is OK you should have aboutclose to 0 Ohm bothOhms between the two cyan marked solderings and between the two yellow ones. Youeach set of pads. You should NOT have any connection between the cyan pads and yellow. If you have no connection onyellow pads. If the filter fails either sides you will havetest it needs to fix itbe replaced.
[* black] If you are uncertain if the EM10filter is missing or obviously broken, measure the two sidesmove on to see ifSTEP 18
[* black] Use a multimeter to test
the are connected. IfEM10 filter - measure the resistance between each of the yellow solder pads, and then between each of the cyan solder pads. If everything is OK you should have aboutclose to 0 Ohm bothOhms between the two cyan marked solderings and between the two yellow ones. Youeach set of pads. You should NOT have any connection between the cyan pads and yellow. If you have no connection onyellow pads. If the filter fails either sides you will havetest it needs to fix itbe replaced.