Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #1

Modifica in base a Knut-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* black] Follow step 1-6 of this guide.[guide|4758]
[* black] This will enableleave the logic board just where you need it.
[* black] If you are uncertain if the EM10 is broken, measure the two sides to see if the are connected. If everything is OK you should have about 0 Ohm both between the two cyan marked solderings and between the two yellow ones. You should NOT have connection between cyan and yellow. If you have no connection on either sides you will have to fix it.
[* black] This will enableleave the logic board just where you need it.
[* black] If you are uncertain if the EM10 is broken, measure the two sides to see if the are connected. If everything is OK you should have about 0 Ohm both between the two cyan marked solderings and between the two yellow ones. You should NOT have connection between cyan and yellow. If you have no connection on either sides you will have to fix it.