Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche a questo Step

Modifica in base a Larry Huang-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* icon_caution] The CR Scale is a clear plastic strip that goes across the printer. Be careful to not break it by stretching it too much.
[* green] Pull the right end of the CR Scale to the right and remove the CR Scale from the right tab.
[* black] On the left side, remove the spring coil connected to the CR Scale with tweezers.
[*
blue] Bring the coil section to an upright position with the tweezers.
[*

[*
violet] Push downwards to release foot 1 from the cutout on mounting plate.
[*

[*
black] Turn the coil section counterclockwise to release it from the mounting plate.
[* black] On the left side, remove the spring coil connected to the CR Scale with tweezers.
[*
blue] Bring the coil section to an upright position with the tweezers.
[*

[*
violet] Push downwards to release foot 1 from the cutout on mounting plate.
[*

[*
black] Turn the coil section counterclockwise to release it from the mounting plate.
[* black] Remove spring coil from the hole on the CR Scale.
[* black] Turn the CR Scale 90 degrees to take it out of the tab.

Immagine 2

Eliminato

Immagine 3

Eliminato