Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #1

Modifica in base a You Qing Mei-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* black] *ReleaseRelease the Carriage lock, and move the Carriage Unit to the center by inserting the flat-blade screwdriver into the hole on the right side of the frame, and rotate the white shaft of the Ink System Unit.
[* black] *PullPull the right end of the CR Scale in the direction of the arrow, and remove the CR Scale from the tab on the Right CR Shaft Mounting Plate.
[* black] *DrawDraw out the right end of the CR Scale toward the left direction from the rear of the Carriage Unit.
[* black] *ReleaseRelease the coil section of Torsion Spring 24.7 from the tab on the Left CR Shaft Mounting Plate with tweezers.
[* black] *RemoveRemove Torsion Spring 24.7 from the CR Scale following the next steps: 1. Bring the coil section to an upright position. 2. Push downwards to release foot 1 from the cutout on the Left CR Shaft Mounting Plate. 3. Turn the coil section counterclockwise. 4. Remove Torsion Spring 24.7 from the hole on the CR Scale.
[* black] *TurnTurn the CR Scale 90°, and remove it from the tab on the Left CR Shaft Mounting Plate.
[* black] *ReleaseRelease the Carriage lock, and move the Carriage Unit to the center by inserting the flat-blade screwdriver into the hole on the right side of the frame, and rotate the white shaft of the Ink System Unit.
[* black] *PullPull the right end of the CR Scale in the direction of the arrow, and remove the CR Scale from the tab on the Right CR Shaft Mounting Plate.
[* black] *DrawDraw out the right end of the CR Scale toward the left direction from the rear of the Carriage Unit.
[* black] *ReleaseRelease the coil section of Torsion Spring 24.7 from the tab on the Left CR Shaft Mounting Plate with tweezers.
[* black] *RemoveRemove Torsion Spring 24.7 from the CR Scale following the next steps: 1. Bring the coil section to an upright position. 2. Push downwards to release foot 1 from the cutout on the Left CR Shaft Mounting Plate. 3. Turn the coil section counterclockwise. 4. Remove Torsion Spring 24.7 from the hole on the CR Scale.
[* black] *TurnTurn the CR Scale 90°, and remove it from the tab on the Left CR Shaft Mounting Plate.