Salta al contenuto principale

Modifiche al passo #6

Modifica in base a Evan Noronha-

Modifica approvata da Evan Noronha

Prima di
Dopo il
Invariato

Righe Passo

[* black] Prepare an iOpener and lay it over the lower edge of the digitizer to loosen the adhesive holding the home button gasket in place.
-[* black] Wait about two minutes before moving on to ensure the adhesive has adequate time to soften.
+ [* icon_note] Wait about two minutes before moving on to ensure the adhesive has adequate time to soften.
+[* black] Flip the digitizer panel over and gently push the home button up out of its slot in the front panel.
+ [* icon_caution] Push slowly and apply just enough pressure to slowly separate the gasket from the glass—if you push too hard the gasket will rip.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Nessuna immagine precedente.

Aggiunto

Immagine 3

Nessuna immagine precedente.

Aggiunto