Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #2

Modifica in base a Jeff Suovanen-

Modifica approvata da Jeff Suovanen

Prima di
Dopo il
Invariato

Righe Passo

[* icon_caution] Before you start placing strips, remove all of the old adhesive around the perimeter of the rear enclosure.
[* black] If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
[* black] Use a pair of tweezers to grasp and peel up the edgeeach strip of each adhesive stripadhesive—or if necessary, use a spudger to scrape up the adhesive, and peel with your fingers.
[* black] Use a pair of tweezers to grasp and peel up the edgeeach strip of each adhesive stripadhesive—or if necessary, use a spudger to scrape up the adhesive, and peel with your fingers.
[* icon_reminder] Repeat this process as necessary to remove all of the old adhesive.
[* icon_note] If necessary, use a spudger to scrape up[* black] For best results, after all the remaining adhesive, then peeladhesive is removed, carefully clean the area under the adhesive with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.
[* black] This helps prep the surface so that the new adhesive bonds properly (and
your fingersdisplay won't fall out).
[* icon_note] If necessary, use a spudger to scrape up[* black] For best results, after all the remaining adhesive, then peeladhesive is removed, carefully clean the area under the adhesive with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.
[* black] This helps prep the surface so that the new adhesive bonds properly (and
your fingersdisplay won't fall out).