Salta al contenuto principale

Modifiche al passo #12

Modifica in base a Ben Gottemoller-

Modifica approvata da Ben Gottemoller

Eliminato
Aggiunto
Invariato

Righe Passo

[title] Checking Fit and Burr Elevation
[* black] Before reassembly, check that the conical lower burr and impeller fit well onto the driveshaft with both steel washers underneath.
[* red] The lip on the drive shaft should be within about 0.5mm of the top surface of the conical burr. When the nut is tightened it will squish to about flush.
[* black] If the burr is too high above the lip on the shaft (higher than in the pic), try putting the nut+washer onacorn nut + washers on (See 7, 8, 9 in the pic), tightening hard, and then taking it back off.
[* black] If the burr is too high above the lip on the shaft (higher than in the pic), try putting the nut+washer onacorn nut + washers on (See 7, 8, 9 in the pic), tightening hard, and then taking it back off.
[* black] If the lower burr is still sitting too high on the shaft, take a quick detour to [guide|62905|Step 20|stepid=134180] and then come back.