Modifiche al passo #9

Modifica in base a Ben Gottemoller-

Modifica approvata da Ben Gottemoller

Eliminato
Aggiunto
Invariato

Righe Passo

[title] Worn impeller removal
[* red] Lift out the old impeller making sure the '''TWO thin steel washerwashers''' underneath the impeller doesn'tdo not fall out. These are very important for the overall height of the lower burr and thus grind fineness.
[* orange] NOTE: Discard the fibrous felt washerring below the metal washerimpeller. This is no longer needed as the new impeller design hugs the bushing pedestal more closely and does a good enough job keeping grounds away from the bushing anyway.
[* black] Optional Modding Tip: Replace the metal washer with a washer that's about 0.1 to 0.2 mm thicker if you'd like your grinder to grind even finer than it did before.
[* red] Lift out the old impeller making sure the '''TWO thin steel washerwashers''' underneath the impeller doesn'tdo not fall out. These are very important for the overall height of the lower burr and thus grind fineness.
[* orange] NOTE: Discard the fibrous felt washerring below the metal washerimpeller. This is no longer needed as the new impeller design hugs the bushing pedestal more closely and does a good enough job keeping grounds away from the bushing anyway.
[* black] Optional Modding Tip: Replace the metal washer with a washer that's about 0.1 to 0.2 mm thicker if you'd like your grinder to grind even finer than it did before.