Salta al contenuto principale

Modifiche al passo #12

Modifica in base a Jeff Suovanen-

Modifica approvata da Jeff Suovanen

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Next out: the midframe that housed the motherboard. Clinging to its side we find a small ribbon cable that plays host to the headset button.
[* black] A closer look at the midframe reveals a slot for the little black nub on the back of the left display panel.
[* icon_note] This slot allows the nub to peek through and slide along that white Teflon strip, activating what ''looks'' like a linear [https://en.wikipedia.org/wiki/Potentiometer|potentiometer]—which could behttps://en.wikipedia.org/wiki/Potentiometer|potentiometer]—likely used to track IPD position as you adjust the displays.
[* black] Ready to go deeper, we remove a smaller midframethe twin lens-and-display assemblies from thier housing, and peel awayoff the rubber light-gasket from around the lenses.
[* icon_note] This slot allows the nub to peek through and slide along that white Teflon strip, activating what ''looks'' like a linear [https://en.wikipedia.org/wiki/Potentiometer|potentiometer]—which could behttps://en.wikipedia.org/wiki/Potentiometer|potentiometer]—likely used to track IPD position as you adjust the displays.
[* black] Ready to go deeper, we remove a smaller midframethe twin lens-and-display assemblies from thier housing, and peel awayoff the rubber light-gasket from around the lenses.