Salta al contenuto principale

Modifiche al passo #36

Modifica in base a Jake Devincenzi-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Use wire cutters to cut one of the outer surface-mounted lead down to a length where you can bend it through the nearest hole in the battery contact with about 6 or 7 mm left over.
[* black] Use wire cutters to cut one of the outer surface-mounted lead down to a length where you can bend it through the nearest hole in the battery contact with about 6 or 7 mm left over.
[* black] After bending the lead through the hole, use the same through-hole soldering technique as earlier to solder the battery lead to the hole in the battery contact.