Salta al contenuto principale

Modifiche al passo #23

Modifica in base a Jake Devincenzi-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Locate the semi-circle labeled "T1" and insert the three leads through the holes.
[* icon_caution] Make sure that you line up the flat part of the transistor with the flat edge of the semi-circle on the board. The two end leads fit into the holes on the ends of the flat part of the drawing. The middle lead will need to be bent so that it feeds through the hole closest to the "T1."
[*
black] Insert wisdom hereSolder the joints to the circuit board in the same way as you have in all of the other steps.
[* red] Locate the semi-circle labeled "T1" and insert the three leads through the holes.
[* icon_caution] Make sure that you line up the flat part of the transistor with the flat edge of the semi-circle on the board. The two end leads fit into the holes on the ends of the flat part of the drawing. The middle lead will need to be bent so that it feeds through the hole closest to the "T1."
[*
black] Insert wisdom hereSolder the joints to the circuit board in the same way as you have in all of the other steps.

Immagine 1

Vecchia Versione

Nuova Versione