Salta al contenuto principale

Modifiche al passo #14

Modifica in base a David Hodson-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Use the same soldering techniques to installBend the leads of the small red diode around rectangle D1 as you did to installand insert it into the resistors in the previous stepsterminal marked D1.
[* icon_remindericon_note] Make sure that the cathode (marked by a small black band on the diodeband) lines up with the white band instripe on the circuit board.
[* black] Use the same method you used to solder the resistors to the
board illustrationto install the diode.
[* red] Use the same soldering techniques to installBend the leads of the small red diode around rectangle D1 as you did to installand insert it into the resistors in the previous stepsterminal marked D1.
[* icon_remindericon_note] Make sure that the cathode (marked by a small black band on the diodeband) lines up with the white band instripe on the circuit board.
[* black] Use the same method you used to solder the resistors to the
board illustrationto install the diode.