Salta al contenuto principale

Modifiche al passo #7

Modifica in base a Jake Devincenzi-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Use the same method above to solder the second resistor lead to the circuit board.
[* icon_note] After soldering a joint, if you are going to put the soldering iron down, be sure to place it back in its stand to prevent burning yourself or anything around you.
[* black] Cut the extra length of resistor lead with a pair of cutting pliers. NASA workmanship standards state that any length up to 2.29 mm is acceptable.