Salta al contenuto principale

Modifiche al passo #6

Modifica in base a David Hodson-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Here we are: the moment of truth. It's time to get that solder flowing.
[* black] Set the tip of the soldering iron on the two parts to be connected. In this case, that's the resistor lead and the copper leadtrace on the circuit board.
[* black] Set the tip of the soldering iron on the two parts to be connected. In this case, that's the resistor lead and the copper leadtrace on the circuit board.
[* black] Touch your solder to the tip of your soldering iron to melt it onto the joint. Don't hold it there for more than a second or two.
[* black] Quickly—butQuickly, but not frantically—pullfrantically, pull both the soldering iron and the solder away from the joint.
[* black] Your solder joint should be shiny and conical, and not expand beyond the copper surface leadtrace.
[* black] Quickly—butQuickly, but not frantically—pullfrantically, pull both the soldering iron and the solder away from the joint.
[* black] Your solder joint should be shiny and conical, and not expand beyond the copper surface leadtrace.