Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Jeff Suovanen-

Modifica approvata da Jeff Suovanen

Prima di
Dopo il
Invariato

Righe Passo

-[* red] Using a PH000 screwdriver, remove the seven screws circled in the diagram. The screw sizes are 2.25mm L and 2.40 diameter
+[* black] Using a PH000 screwdriver, remove the following seven screws:
+ [* red] Four (longer) Phillips 000 screws
+ [* orange] Three shorter Phillips 000 screws
[* black] Once all of the screws are removed, proceed to using a plastic spudger to pry the metal cover off.
[* black] There are two clips near the bottom, right above that battery, so start by prying on the bottom edge of the plate.

Immagine 1

Vecchia Versione

Nuova Versione