Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Brian-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] NextThe next step will be to make the edge connector out of a scrap piece of PCB.
[* black] NextThe next step will be to make the edge connector out of a scrap piece of PCB.
[* black] I chose a section with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'.
[* black] The size of the traces almost matches a PCI connector. You might be able to scavenge a section from an old card. However, the traces leading away from the edge must travel straight together for a while so you have enough room for the cable for connect to them.
[* black] I've ordered a prototype connector from [http://batchpcb.com/index.php/Home|BatchPCB] and will make it available on their market place once I verify that it works.