Aggiusta le tue cose Community Store

Modifiche al passo #16

Modifica di Netmammal —

Modifica approvata da Netmammal

Prima di
Dopo il
Invariato

Righe Passo

[title] Test again?
-[* black] If you have not tested the fan yet, it is recommended that you attach the connector to the fan header on the circuit board, put water in the tank, temporarily re-attach the connector for the ribbon cable to the control panel.
-[* icon_reminder] You will have to have the cube right-side up so that the float switch lets the unit know that there is water in the reservoir, which means that it will be sitting on top of those open circuit boards.
+[* black] If you have not tested the fans yet, it is recommended that you attach the connector to the fan header on the circuit board, put water in the tank, temporarily re-attach the connector for the ribbon cable to the control panel.
+[* icon_reminder] You will have to have to turn the cube over to be right-side up so that the float switch lets the unit sense that there is water in the reservoir. This means that the cube will be sitting on top of those open circuit boards.
[* icon_caution] Just be careful about putting your hand near that power supply when you have this plugged in!
[* icon_caution] ...And if you have been resting this on a cookie sheet, find a towel or something else non-conductive so that it is not resting on metal, before you plug it in.
[* black] Having done all of that, when you plug it in, and turn it on using the control panel on the top, the fans should spin.