Modifiche al passo #14
Righe Passo
| + | [title] Create spot for 3-way switch |
|---|---|
| + | [* black] The 3-way switch will be positioned so that you can use a pencil point poked through the grill to change the setting after your ChiliCube is re-assembled. |
| + | [* black] I did not photo it, but I used a dremel tool to cut part of the flange which is just behind the grill on the front-side of the cube when it is upright. |
| + | [* black] The switch will probably stay here on its own, but add a cable tie, strung through two tiny holes drilled on either side of the switch to make sure it does not pop out during reassembly. |
Immagine 1
Nessuna immagine precedente.
Aggiunto
Immagine 2
Nessuna immagine precedente.
Aggiunto
Immagine 3
Nessuna immagine precedente.
Aggiunto