Modifiche al passo #10
Righe Passo
| - | [title] |
|---|---|
| + | [title] Prepare cables for new fan |
| [* black] The new fan is an Antec, Inc TRICOOL 92mm Tricool Case Fan comes in two versions. The less expensive ~$5 one which used here has "standard" bearings, (sleeve?), the DBB (Double Ball Bearing) version is almost twice as much per fan. Its not quieter, but odds are it will last longer. | |
| [* black] On this fan, I first attached the "dongle" that adapts the 3-pin connector on the fan to the 4-pin old-school molex connector. This is to figure out which wire is positive, negative, and speed sensor (which will not get used here) | |
| - | [* black] Mark on you new fan which conductor is black (negative), and positive (red). Cut the 3-pin connector off. |
| - | [* black] Crimp black to black and red to red (or solder/splice as you see fit.) |
| + | [* black] Mark on you new fan which conductor is black (negative), and which is positive (red). Cut the 3-pin connector off. |