Aggiusta le tue cose Community Store

Modifiche al passo #3

Modifica di Jordan RiberSmith —

Modifica approvata da Jordan RiberSmith

Prima di
Dopo il
Invariato

Righe Passo

[* icon_note] Note which wire is connected to which lead before continuing. There are no markers on the circuit board to indicate where each wire belongs.
-[* black] Heat the solder connecting the black speaker wire to the circuit board, until the solder melts. Then pull the wire free of the liquid solder.
-[* icon_caution] To avoid damaging the circuit board, touch the tip of the soldering iron to the solder only as long as needed to just melt it. Immediately remove the soldering iron when finished.
+[* black] De-solder the black speaker wire from the circuit board.
+[* icon_caution] To avoid damaging the circuit board, touch the soldering iron tip to the solder for as short a time as possible.