Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Chris Hoffman-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* redblack] Remove the left 3 mm and right 8 mm (right screw is unnecessary to remove on some models)
[* orange] One 3.25mm Phillips #000 (Head: 4mm dia. x .5mm thick)
[* red] One 8.5mm Phillips #000 (Head: 4mm dia. x .75mm thick
[* icon_note] The
Phillips screws securing the MagSafe board and the left speaker to the lower case. The next two speaker steps are unnecessary one some models as are steps 16 and 17 as the magsafe will drop in without removing these.
[* redblack] Remove the left 3 mm and right 8 mm (right screw is unnecessary to remove on some models)
[* orange] One 3.25mm Phillips #000 (Head: 4mm dia. x .5mm thick)
[* red] One 8.5mm Phillips #000 (Head: 4mm dia. x .75mm thick
[* icon_note] The
Phillips screws securing the MagSafe board and the left speaker to the lower case. The next two speaker steps are unnecessary one some models as are steps 16 and 17 as the magsafe will drop in without removing these.

Immagine 1

Vecchia Versione

Nuova Versione