Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Luis Rivera Reyes-

Modifica rifiutata da Adam O'Camb

Prima di
Dopo il
Invariato

Righe Passo

[* red] With the screws removed, use a plastic opening tool to lightly pry the board up over a plastic positioning peg (circled red).
- [* icon_note] These images show a metal spudger, but you should use plastic opening tools to prevent possible damage to your device.
[* blue] Insert the tip of a spudger where the upper screw was located and push the board inward while prying up with the plastic opening tool.
-[* black] Once both tools are in position, lightly pry with the metal spudger, just enough for the board to lift off of the positioning peg and then push inward with the black spudger. Notice how in the last picture the board is beginning to separate from the corner.
+[* black] Once both tools are in position, lightly pry with the metal spudger, just enough for the board to lift off of the positioning peg and then push inward with the plastic spudger.