Salta al contenuto principale

Modifiche al passo #3

Modifica in base a Evan Noronha-

Modifica approvata da Evan Noronha

Prima di
Dopo il
Invariato

Righe Passo

[* red] Use a pair of tweezers to disconnect the three black antenna cables from the motherboard.
-[* black] Use the flat end of the spudger tool to carefully pry up the motherboard. For the first Shield there is a flatribbon at the right side underneath the board, this is for the Stylus. At the left side there are 2 flatribbons for the cameras underneath the board, so loosen the cameras before lifting the board.
+[* black] Use the flat end of the spudger tool to carefully pry up the motherboard.
+ [* icon_note] In the first Shield, the stylus ribbon cable is located under the right side of board. While there are 2 additional cables for the cameras underneath the left end of the board. Be sure to loosen the cameras before lifting the board.