Aggiusta le tue cose Community Store

Modifiche al passo #5

Modifica di alex —

Modifica approvata da alex

Prima di
Dopo il
Invariato

Righe Passo

-[* icon_reminder] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red wire. However, in this case the red wire goes with the white wire (it all depends on how the manufacturer ships it). The white wire extends from the ***Attached power cord***
+[* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red wire. However, in this case the red wire goes with the white wire (it all depends on how the manufacturer ships it). The white wire extends from the ***Attached power cord***
[* red] Twist the red wire that is coming from the ***Coil Assembly*** with the white one, and the black wire with the black one.
[* icon_caution] CAUTION: Match the wires correctly, Black with Black, and Red with White. If you matched the wrong wire, it will cause the clippers to have a short circuit (electrical malfunction) when you plug the electrical cord into an outlet.
[* yellow] After you have twisted the wires together, use electrical tape to wrap the stripped wires. Leave some tape over the ends of the wires, and below the cutoff of the rubber around the wire as shown in the photo. Wrap the tape around the wires as tight as possible.
[* icon_note] To complete this repair and reassembly, follow these steps in reverse, starting from the end of step 3 up to the beginning of step 1