Modifiche al passo #4
Modifica di Marcus Thomas —
Modifica approvata da Marcus Thomas
- Prima di
- Dopo il
- Invariato
Righe Passo
| - | [* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires leading from the ***Coil Assembly*** to the *** |
|---|---|
| - | [* icon_note] Black being {Negative} goes with the Black wire, Red being {Positive} goes with the white cord |
| + | [* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires, leading from the ***Coil Assembly*** to the ***Attached power cord***, approximately half way between the two ends of both wires. |
| + | [* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with the white cord extending from the ***Attached power cord***. |
| [* red] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires . | |
| - | [* icon_reminder] Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted. |
| + | [* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted. |