Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Jake Bertholf-

Modifica approvata da Jake Bertholf

Prima di
Dopo il
Invariato

Righe Passo

-[* black] Connect the new motherboard to the bottom two connectors and then place the motherboard back into its original position. NOTE: Make sure the motherboard is fully in place and not sticking up past its original position, as this could cause the motherboard to snap when the top of the device is re-attached.
+[* black] Disconnect the white ribbon cable attached to the button membrane, which will completely separate the motherboard from the device.