Salta al contenuto principale

Modifiche al passo #2

Modifica in base a Joe Durand-

Modifica approvata da Joe Durand

Prima di
Dopo il
Invariato

Righe Passo

-[* black] Push the motherboard towards the USB Charging Port, then lift the other side of the board up.
-[* black] Slide the board out from under the white grooves near the USB Charging Port.
-[* icon_note] If the motherboard won't budge, be sure that the square component on the bottom of the motherboard clears the edge of the speaker.
+[* black] Remove the motherboard from the casing.
+ [* red] Push the motherboard towards the USB Charging Port.
+ [* blue] Lift the opposite end the board up.
+[* violet] If the motherboard won't budge, be sure that the square component on the bottom of the motherboard clears the edge of the speaker.
[* icon_caution] During reassembly, make sure the motherboard is fully installed and not sticking up past its original position, as this could damage the motherboard.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Nessuna immagine precedente.

Aggiunto

Immagine 3

Nessuna immagine precedente.

Aggiunto