Menü

Le tue impostazioni

Modifiche al passo #1

Modifica in base a bushing-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Remove 4 Phillips screws from the board.
[* black] Lift the main board from the bottom screenend and touch sensor assembly up out offlip it over to reveal the bottom case / framelast connector.
[* icon_caution] Keep the main board fairly close to the case, making sure not to damage the last ribbon cable holding it in place.
[* red] Remove 4 Phillips screws from the board.
[* black] Lift the main board from the bottom screenend and touch sensor assembly up out offlip it over to reveal the bottom case / framelast connector.
[* icon_caution] Keep the main board fairly close to the case, making sure not to damage the last ribbon cable holding it in place.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Nessuna immagine precedente.

Aggiunto