Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #1

Modifica in base a James Loy-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* red] Locate two more ZIF connectors on the front of the motherboard. The first is a black connector directly below the lens. The second is a brown connector on the side of the lens.
[* black] Use the Spudger to rotate the black ZIF connector tab up and pull the connectorribbon out that it was holding.
[* black] Use the Spudger and pull each end of the brown ZIF connector tab directly out in the direction that the ribbon is going. You must unlatch both ends before the connector can pull out. Once both ends are unlatched, pull ribbon cable out.
[* red] Locate two more ZIF connectors on the front of the motherboard. The first is a black connector directly below the lens. The second is a brown connector on the side of the lens.
[* black] Use the Spudger to rotate the black ZIF connector tab up and pull the connectorribbon out that it was holding.
[* black] Use the Spudger and pull each end of the brown ZIF connector tab directly out in the direction that the ribbon is going. You must unlatch both ends before the connector can pull out. Once both ends are unlatched, pull ribbon cable out.