Salta al contenuto principale

Modifiche al passo #3

Modifica in base a Courtney Crockett-

Modifica approvata da Evan Noronha

Eliminato
Aggiunto
Invariato

Righe Passo

[* blackblue] Insert the flat end of a spudgerscrewdriver in between the lower casecasing and lower front panel near the top right corner of the DSi.
[* blackgreen] Carefully run the spudgerflat screwdriver along the right edge of the DSiouter casing, creating an opening inbetween the body and the processcasing.
[* blackgreen] Continue running the spudger alongflat screwdriver around the backsidebody of the DSi until the majority of the lower case has been separated from the lower front panelseparated.
[* blackblue] Insert the flat end of a spudgerscrewdriver in between the lower casecasing and lower front panel near the top right corner of the DSi.
[* blackgreen] Carefully run the spudgerflat screwdriver along the right edge of the DSiouter casing, creating an opening inbetween the body and the processcasing.
[* blackgreen] Continue running the spudger alongflat screwdriver around the backsidebody of the DSi until the majority of the lower case has been separated from the lower front panelseparated.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Vecchia Versione

Nuova Versione