Salta al contenuto principale

Modifiche al passo #3

Modifica in base a Courtney Crockett-

Modifica approvata da Evan Noronha

Eliminato
Aggiunto
Invariato

Righe Passo

[* bluered] Insert the flat screwdriverspudger in between the lower casing and lower panel near the top right corner of the DSi.
[* greenblue] Carefully run the flat screwdriverspudger along the edge of the outer casing, creating an opening between the body and the casing.
[* greenblue] Continue running the flat screwdriverspudger around the body of the DSi until the majority of the lower case has been separated.
[* bluered] Insert the flat screwdriverspudger in between the lower casing and lower panel near the top right corner of the DSi.
[* greenblue] Carefully run the flat screwdriverspudger along the edge of the outer casing, creating an opening between the body and the casing.
[* greenblue] Continue running the flat screwdriverspudger around the body of the DSi until the majority of the lower case has been separated.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Vecchia Versione

Nuova Versione