Modifiche al passo #3
Modifica di Christina Walden —
Modifica approvata da Christina Walden
- Prima di
- Dopo il
- Invariato
Righe Passo
| - | [* black] Release the two cables by lifting up their respective clips with a spudger. |
|---|---|
| + | [* black] Separate the two parts of the body of the camera slightly. |
| + | [* red] Release the two cables by lifting up their respective clips with a spudger. |
| + | [* icon_note] Make sure not to pull too hard because there are connector ribbons. |
| + | [* icon_note] Detach the connector ribbons before fully separating the camera into two pieces. |
| [* icon_note] These pictures were taken after the connector ribbons were released and the camera was separated into two parts. It is difficult to show the connector ribbons while the two pieces of the camera are still connected. You will need to release the connector ribbons while the camera is still in one piece before you can separate it like the pictures. |