Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #27

Modifica in base a Sam Goldheart-

Modifica approvata da Sam Goldheart

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_caution] Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
[* black] Flip the iPad back over and insertInsert a plastic card betweenunder the logic board side, speakerbattery from the Lightning cable connector end of the battery and the rear caseiPad.
[* black] Flip the iPad back over and insertInsert a plastic card betweenunder the logic board side, speakerbattery from the Lightning cable connector end of the battery and the rear caseiPad.
[* icon_note] If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.