Salta al contenuto principale

Modifiche al passo #2

Modifica in base a Brett Hartt-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Insert wisdom hereUsing the flat end of a spudger, pry the left speaker out of its socket on the front bezel.
[* black] De-route the speaker cable along the top edge of the screen.
[* icon_note] Work carefully and slowly, holding onto the wire and not the speaker itself. The solder joints may break if pulled on too hard.
[* black] In the same manner described above, remove the right speaker from its socket on the front bezel.
[* black] Place both speakers on the back of the upper LCD
.
[* black] Insert wisdom hereUsing the flat end of a spudger, pry the left speaker out of its socket on the front bezel.
[* black] De-route the speaker cable along the top edge of the screen.
[* icon_note] Work carefully and slowly, holding onto the wire and not the speaker itself. The solder joints may break if pulled on too hard.
[* black] In the same manner described above, remove the right speaker from its socket on the front bezel.
[* black] Place both speakers on the back of the upper LCD
.