Modifiche al passo #9
Modifica di Philip Le Riche —
Modifica approvata da Philip Le Riche
- Prima di
- Dopo il
- Invariato
Righe Passo
| + | [* black] With the lens back plate removed, temporarily replace one of the 4 screws which secured it. It will not be possible to drive it fully home; only tighten it until resistance is felt. |
|---|---|
| + | [* black] Lift out the three zoom motor gears and put them aside. |
| + | [* black] Lift the lens off the bench and using a small flat screwdriver, gently turn the gear teeth which the last zoom motor gear engaged with until the lens is open approximately half way. |
| + | [* black] Now feed the two ribbons protruding through a slot in the barrel back into the lens. |
| + | [* black] Resting the lens face-down on the bench, retract it to the closed position by turning the gear teeth in the opposite direction. |
| + | [* black] Remove the screw which had been temporarily reinserted. |
Immagine 1
Nessuna immagine precedente.
Aggiunto
Immagine 2
Nessuna immagine precedente.
Aggiunto