Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[title] Bypassing the "first use" initialization setup
-[* black] To remove the printhead from the printer, open the scanner lid, and let it come to the stopping point in the printer.
+[* black] To remove the printhead from the printer, open the scanner lid, and let it come to the stopping point in the printer. See [guide|32772|this] if you need a dedicated guide. ***This does not cover my bypass. Be aware of that much.***
[* red] Lift the handle holding the printhead in up, as this will release the printhead.
[* black] Lift up on the printhead, and it should be removed from the printer.
[* black] ***Unplug the printer and leave it as found. If you screw this part up, you will likely lose your alignment settings!***
-[* icon_reminder] Let me say it one more time-CLOSING THE PRINTER MAY CAUSE THE PRINTER TO SEE YOU REMOVED THE PRINTHEAD! Leave it open to retain the printhead calibration. If you find the printer closed, open it up and make sure it does not get power.
-[* icon_caution] ***If you lose your printhead, alignment and calibration data by screwing this up, you will waste 1/2 OR MORE of ALL your ink tanks!***
-[* icon_note] If you manage to screw this up, expect to be buying new ink cartridges. Just saying.
+[* icon_reminder] Closing the printer will cause it to see you removed the printhead. Leave it open to retain the printhead calibration. If you find the printer closed, evaluate. It it had power the calibration is a loss. If not, open it and hope for the best.
+[* icon_caution] ***If you lose your printhead settings you will waste 1/2 OR MORE of ALL your ink tanks.*** If this happens, just be ready to go to Walmart and get new ink tanks.