Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[title] Bypassing the "first use" initialization setup
-[* black] To remove the printhead from the printer, open the scanner lid and let it come to the stopping point in the printer. See [guide|32772|this] if you need a dedicated guide on removal. Once you do this, follow the steps on getting around the first use alignment and ink waste. This printer wastes 1/4 of any Retail ink you install if this has to be repeated.
-[* red] Unplug the printer with the head installed ***first*** to ensure you do not lose the alignment. Once you unplug the printer, remove the printhead. ***DO NOT DO THIS UNTIL THE POWER IS CUT OFF! FAILURE TO DO THIS WILL ERASE THE ALIGNMENT FROM THE PRINTER!***
-[* black] To remove the printhead: Lift the handle that holds the printhead in up, and pull up to remove it from the printer.
+[* black] ***Unplug the printer before doing ANYTHING. If you do not do this you risk losing the calibration data.***
+[* black] Remove the printhead from the printer. To do this, open the lid and remove the ink tanks. Once the ink is removed, lift the latch holding the printhead up, as shown. Remove the printhead once this is done. ***Note: If you need clearer instructions, follow [guide|32772|this guide] for additional instructions.***

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Vecchia Versione

Nuova Versione