Salta al contenuto principale

Modifiche al passo #8

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[title] Reinstall the printhead and ink
-[* icon_caution] ***Since the calibration will be erased if the printhead errors out, it is best to wait until you are satisfied and certain the printhead is dry before reinstallation.***
-[* icon_reminder] ***If your printer says Printhead Problem, the calibration data is gone.*** Check if the printhead is dry and installed correctly if this happens. ***WARNING:*** Since printhead initialization uses a lot of ink (~1/2 of non XL carts), it is best to use new ink cartridges.
-[* icon_note] While the printer will not treat the printhead as "new", a ***Printhead Preparation*** process must run. This is unavoiable.
-[* black] Once the printhead is satisfactorily dry, reinstall it in the printer. Do this in the reverse order the printhead eas removed. Install your ink cartridges when the printhead is installed and plug the printer in.
+[* icon_caution] ***Since the calibration will be erased if the printhead errors out, wait until you are sure the prinhthead is dry before installation.***
+[* icon_caution] ***If your printer says Printhead Problem, the calibration data is gone.*** Check if the printhead is dry and installed correctly if this happens. ***WARNING:*** Since printhead initialization uses a lot of ink (~1/2 of non XL carts), it is best to use new ink cartridges.
+[* icon_reminder] While the printer will not treat the printhead as "new", a ***Printhead Preparation*** process must run. This is unavoiable.
+[* black] Once the printhead is satisfactorily dry, reinstall it in the printer. This is done in the reverse of how it was removed. Install your ink cartridges and plug the printer in.