Salta al contenuto principale

Modifiche al passo #8

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[title] Reinstall the printhead and ink
-[* icon_caution] ***If the printer is plugged in without a printhead and ink installed, the calibration data will be erased!***
-[* icon_caution] ***If the printhead is not satisfactorily dry, do not touch the printer until you are satisfied it is fully dried out.***
+[* icon_caution] ***If the printer is plugged in without a printhead and ink installed, the calibration data will be erased! It is best to not not touch the printer until it is satisfactorily dry.***
[* icon_reminder] If your printer says ***Printhead Problem***, the calibration data will be erased. If this happens, check if the printhead is installed correctly. ***WARNING: Printhead initialization uses a lot of ink. On non XL cartridges, it can use ~1/2 of the ink in the installed cartridge. New ink should be purchased if this happens.***
[* icon_reminder] ***Note:*** While the printer will not treat the printhead as "new", it will need to run a ***Printhead Preparation*** process. This cannot be avoided.
[* black] Once the printhead is satisfactorily dry, reinstall it in the printer. This should be done in the reverse order it was removed. After the printhead is installed, install your ink cartridges. Once this is done, it is safe to plug the printer in.