Salta al contenuto principale

Modifiche al passo #8

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[title] Reinstalling the printhead and ink
-[* black] Once the head is wiped dry and has sat long enough to clear the water from the printhead, put the printhead back in the printer. ***Important: Do not plug the printer in until this is finished. Doing this wrong will erase the printhead calibration.***
-[* black] Reinstall the printhead. To do this, reverse the way you removed it from the printer.
-[* black] Put the ink cartridges back in the printer.
-[* black] Plug the printer back in, and close the lid. The printer will run a cleaning once you do this, but you lose substantially less ink then you will lose if you were to reset the stored calibration.
-[* icon_note] If you continue having problems with the quality, try replacing the ink cartridges. If this does not work, the printhead is very likely to be beyond repair. A new printhead will cost ~$80 brand new, so they are not worth replacing. It may not hurt to try another head clean at this point to try and save it.
-[* icon_reminder] If you get a message that says ***Printhead Problem***, you did not replace the printhead correctly. At this point you will want to buy a new set of ink cartridges, since you will lose ~1/2 of the ink on retail cartridges. It will also complain about the ink being used, if you use your old ink cartridges to do this, but it should accept them.
+[* icon_caution] ***Wait until the printhead is fully dry before replacing it. I recommend waiting 4-6 hours or putting the printhead in front of a fan to help speed the drying process up.***
+[* icon_caution] ***DO NOT plug the printer back in until the printhead and ink cartridges are replaced. If you get this wrong, your calibration data will be erased.***
+[* icon_note] If your printer says you have a ***Printhead Problem***, you failed to preserve the calibration data. The printhead was NOT replaced correctly. Your printer will use ~1/2 of your ink cartridges to restore the calibration stored in the printer. ***Note: If your inks are used and this happens, your printer will complain about the ink being used.***
+[* black] Once the head is wiped dry and has sat long enough to clear the water from the printhead, put the printhead back in the printer.
+[* black] Reinstall the printhead. To do this, follow the procedure to remove it in reverse. Put the ink cartridges back in once this is done.
+[* black] ***Once the printhead and ink is replaced***, close the lid and plug the printer back in. Your printer will run a "printhead preparation''' procedure, which cannot be interrupted.